Microceph upgrade

https://canonical-microceph.readthedocs-hosted.com/en/latest/how-to/reef-upgrade/

Overview This guide provides step-by-step instructions on how to upgrade your MicroCeph cluster from the Quincy release to the Reef release. Follow these steps carefully to prevent to ensure a smooth transition.

Procedure Optional but Recommended: Preparation Steps Carry out these precautionary steps before initiating the upgrade:

Back up your data: as a general precaution, it is recommended to take a backup of your data (such as stored S3 objects, RBD volumes, or cephfs filesystems).

Prevent OSDs from dropping out of the cluster: Run the following command to avoid OSDs from unintentionally dropping out of the cluster during the upgrade process:

sudo ceph osd set noout Checking Ceph Health Before initiating the upgrade, ensure that the cluster is healthy. Use the below command to check the cluster health:

sudo ceph -s Note: Do not start the upgrade if the cluster is unhealthy.

Upgrading Each Cluster Node If your cluster is healthy, proceed with the upgrade by refreshing the snap on each node using the following command:

sudo snap refresh microceph --channel reef/stable Be sure to perform the refresh on every node in the cluster.

Verifying the Upgrade Once the upgrade process is done, verify that all components have been upgraded correctly. Use the following command to check:

sudo ceph versions Unsetting Noout If you had previously set noout, unset it with this command:

sudo ceph osd unset noout You have now successfully upgraded to the Reef Release.